Audio Settings

💡 After you have switched on the input signal (Turn on the input signal. Tap the speaker(X)-icon), take a look at the audio buffer values.
In total, these should NOT be higher than about 600 ❗.
You can vary the value on the right by setting the "Buffer Factor" .
Then the -❕LATENCY❕- is rated again ❗
💡 Please note: The latency in 'ms' is only an approximate statement that is intended as a guideline.
Please keep in mind that the distance between you and the speaker 34 cm (13,50394 in) each corresponds to approx. 1 ms.

Midi Settings

💡 You can use a ❕midi foot controller❕ in the following way:
With ❕bluetooth midi❕ adapter. To do this, you must first install
a third-party app "Bluetooth Midi Connect"
Once the contact has been established, the midi device also appears here in the list.

💡 Via USB e.g. SoftStep 2 in toggle mode
💡 "Automatic order" means: The midi switches 1-11 correspond exactly to the
order of the effects in your effects \"device stack\".
if this is switched off, you can set the order in the corresponding effect view.
In the effect controls, switch-no. = 0 means: Footswitch not assigned. (default)
💡 In your midi hardware the switches should be
assigned C#21- CC#31.
They correspond to "Effect Bypass" No. 1 - 11
💡 Expr.-Pedal should be assigned
CC#102 or CC#7, 0-127 below Out-Volume [ % ]